Batteries
iM5 Battery Capacity: 534 Wh Nominal voltage: 46.8 V Maximum charging current: 4 A Dimensions: 366 × 65 × 76.8 mm CAN-BUS Energy support for accessories: 70 W (maximum) Weight: 2600 g iM8 Battery Capacity: 800 Wh Nominal voltage: 46.8 V Maximum charging current: 4 A Dimensions: 503.7 × 65 × 76.8 mm CAN-BUS Energy […]
Interface
Head Unit+ Action button: system on/off and change of assistance level 1.9’’ color display Light sensor CAN-BUS, ANT+ and Bluetooth® Dimensions: 83 × 38 × 16 mm IP67 Operating temperature: -10ºC to 50ºC Weight: 65 g TRIO Set of three buttons to control the system Can be installed on either side of the 22 mm […]
Speed Sensor
Speed Sensor Sensor Reads the speed of the rear wheel Capable of detecting up to 84 pulses per revolution Water ingress protection: IP67 Weight: 10 g Sensor Mount Adapter to fix the sensor to the bicycle frame Allows adjustment to ensure correct measurement Weight: 4 g Tone Disc Tone disc placed on the rear brake […]
Connectors / Wiring
M40 Wiring Connection system of the M40 System Weight: 86 g HU Wiring Compatible with both HU+ and HU Standard Two versions, with and without accessory connection Weight: 30/40 g (without/with accessories) Charging Port Cover Necessary to fix the charging port to the frame Weight: 20 g
Introduction
WARNING This section describes how to use the system and must be read before it is put into operation.
Use of the system
1.1.1 Before first use For proper operation, ensure that the eBike system is fully connected and correctly assembled. Before first use, fully charge the battery using the active charger. For additional information on how to charge your eBike, refer to the relevant section of the manual. Also, before starting to ride, make sure that the […]
Switching the system on and off
System start-up Press the button on the main control unit once to switch on the system. The display of the main control unit will turn on and show a welcome animation. If everything is correct, once the start-up process is complete, the system’s home screen will appear. System shutdown To switch off the system, simply […]
Connection with the MySmartbike Application
Download the MySmartbike application to guide you through this process.To activate pairing mode, with the eBike switched off, press and hold the central button for 5 seconds and the pairing screen will appear. When the connection process has been successfully completed, the following screen will appear. When the MySmartbike app disconnects from the system, the […]
Accessories and Controls
1.4.1 TRIO 1.4.1.1 Pairing Download the MySmartbike application to guide you through this process. This mode is specifically used for the first experience when connecting the Trio for the first time with the Head Unit+. To activate pairing mode, press and hold buttons 1 and 3 for about 5 seconds: The small LED indicator on […]
System Status
The system has three different operating states: Normal: everything is correct. The system displays the screens configured by the user through the MySmartbike app. Alert: an ALERT message appears in yellow on the screen. Although an event has occurred in the system, riding and assistance are not limited. Error: an ERROR message appears in red […]
